13. Operating Instructions
2-68
1) Check oil and water for leaks, and visually inspect the
implement, the machine, and the undercarriage by
walking around them.
If there are any leaks of oil or water, or any observed ab-
normality, take corrective action.
2) Completely fill the fuel oil tank.
3) Confirm that the engine room compartment is free of
any foreign matter.
Paper or dust in the engine room may cause fire. Re-
move them if any.
4) Remove mud adhering to the undercarriage of the ma-
chine.
Make sure to lock up the following parts :
(1) Engine hood B
(2) Engine hood rear cover
(3) Side door (for cabin)
Note :
The starter switch key (1) is used to lock all of the parts
mentioned above.
13-18. Inspection requirements after stopping the engine
13-19. Locking
(1)
009142-00X
009143-00X
(2)
(3)
009144-00X
To Next Page
Loading...
