2-80
14. Transportation
For safety in transporting the machine, comply with all ap-
plicable regulations and laws.
To load or unload the machine, be sure to use the ramp
plates and follow the procedure below:
14-1. Loading and unloading the machine
• Be careful when loading and unloading the ma-
chine, because it is a job of high hazard poten-
tial.
• Load or unload the machine on level, solid
ground far away from the shoulder of the road.
• Load or unload the machine at a low engine
speed.
• Use ramp plates of adequate strength having
hooks. Check to see that the ramp plates are
wide, long, and thick enough to safely sustain
the machine so that you can load or unload safe-
ly. To prevent the ramp plates from bending too
much, support them with blocks.
• Securely hook the ramp plates to the deck of the
truck so that they will not come off.
• Remove mud, grease, and other slippery depos-
its from the track shoes, and grease, oil, and ice
deposits from the ramp plates to prevent the ma-
chine from skidding.
• Never change the travel direction on the ramp
plates. If you need to change the travel direction,
go back down on the ramp plates, then do this.
• Swing slowly on the truck bed if necessary since
the foothold is unstable.
• Make sure that the side door of the cabin is
locked, whether in the open or closed position.
Never open or close the side door on the ramp
plates, to prevent it from swinging violently.
To Next Page
Loading...
