13. Operating Instructions
2-78
Work on level ground with good footing. If two or more per-
sons work together, communicate with signals selected
beforehand for safety.
Replacement procedure
Replace the bucket according to the following procedure:
1) Park the machine on level, flat ground, and lower the
bucket onto the ground.
2) Stop the engine.
3) Clean around the bucket pin to prevent foreign material
from entering the pin holes.
4) Remove pins A and B.
IMPORTANT
• Keep the pins away from dirt or mud.
• The machines have dust seals on either end of the
bushing. Be careful not to damage them.
13-22. Replacing the bucket without the quick coupler
• When driving pins into the bucket with a ham-
mer, metal chips may fly. If metal chips should
get into your eyes, they can cause serious injury.
Use goggles, a hard hat, and gloves for safety
when replacing the bucket.
• After removing the bucket, place it on solid
ground in a stable position.
• When aligning the holes for pin A and pin B, be
careful not to insert your fingers into those holes
to prevent serious injury to your fingers. Visually
check the alignment of the holes.
Bucket cylinder
Link
Arm
Pin A
Pin B
000443-00E
O-ring
Bucket
000444-00E
(A)
(B)
000445-00X
To Next Page
Loading...
