14. Transportation
2-81
1) Firmly brake the truck and apply wheel stoppers to the
tires. Securely install the ramp plates on the bed of the
truck in a position where the center of the truck aligns
with the center of the machine. Make sure that the left
and right ramp plates are at the same level.
The ramp plates should be set at an angle of less than
15 degrees.
Determine the span between the ramp plates on the
basis of the centers of the track shoes.
Do not operate the high-speed pedal.
2) Return the accelerator lever to reduce engine speed.
3) Travel toward the ramp plates at a low speed, and load
or unload the machine with the implement lowered as
close as possible to the deck of the truck.
Do not operate any levers other than the travel levers
while driving on the ramp plates.
4) Load the machine in a safe position on the truck.
Hook
Ramp plate
Span between
ramp plates
Less than
15 degrees
Block
Stoppers
000503-00E
High-speed pedal
009152-00E
Slow idling
009151-00E
To Next Page
Loading...
