29. Handling Air Conditioner (for Model Z35 with Cabin)
5-8
5) Adjust the air direction with the air outlet grille.
• Set the fan switch for ventilation to apply preload to the
inside of the cabin when the air conditioner is not used,
so that no dust can come into the cabin easily during op-
eration.
IMPORTANT
Be sure to turn the air conditioner ON after starting the
engine to prevent excessive force to the compressor
etc.
29-2-2. Heating
1) Set the fan switch at any of the three positions
(Low, Medium or High).
2) Set the temperature control lever at the WARM position
(the left position).
3) Turn the air conditioner switch OFF. (The lamp goes off.)
29-2-3. Heating for dehumidification
(In the case that the window glass tends to get fogged in
rainy weather in spring or autumn.)
With the heating turned on, turn the air conditioner switch
ON (the lamp goes on).
• If the temperature inside the cabin is low, dehumidifica-
tion might not work because the compressor does not
operate even if the air conditioner switch is turned ON.
29-2-4. Stop
1) Turn the air conditioner switch OFF. (The lamp goes
off.)
2) Turn the fan switch OFF.
• The air conditioner also stops only by turning the fan
switch OFF.
Grille
Knob
OpenClose
Air direction
016147-00E
Air conditioner switch
ON
(The lamp goes on.)
Fan switch
Temperature control lever
001307-00E
To Next Page
Loading...
