12. Description of Control Devices
2-10
(1) Lock levers (for implement control levers on both sides, boom swing pedal, blade lever and
travel lever)
The lock levers lock the implement control levers, boom swing pedal, blade lever and travel levers. When
pulling the left lock lever back, the control lever stand (L) comes up. While the control lever stand (R)
does not come up when pulling the right lock lever back.
• When leaving the operator's seat, be sure to put the bucket
on the ground and move the lock levers to the lock posi-
tions. Keep in mind that if you should touch the unlocked
lever inadvertently, a serious accident could occur.
• Be sure to place the lock levers securely in position. If not,
they could come out of the lock position. Thus always
make sure that the lock levers are in position as illustrated
in the right figure.
• When pulling the lock levers back, be careful not to touch the implement control lever.
• Remember that if the lock levers are not pulled back fully, the implement will not be locked.
IMPORTANT
The machine uses a hydraulic lock system. If the lock levers are in the lock position, all the hy-
draulic cylinders for the boom, arm, bucket, boom swing, blade and an actuator in the P.T.O. cir-
cuit as well as the swing and travel motors will not activate although the control levers and
pedals, and the P.T.O. switches are free to move.
12-3. Control levers and pedals
015404-00E
(7)
(1)
: Conpy type only(9)
(12)
(10)
(8)-1) (8)-2)(11)(1)(2)
(4)
(6)
(12)
(5)
(5)
(3)
Lock
(Left side)
Lock lever
008999-00
To Next Page
Loading...
