Rev. 00 02/21
62
Operation OptiCenter OC09
5. The extraction system is switched off by default, but can be
manually switched on and off as needed
6. Open the OptiHopper cover and visually check the fluidization and
OptiHopper exhaust air.
Fluidization is set correctly when the powder "boils" slightly.
– If necessary, adjust again on the appropriate pressure regulator
The OptiHopper exhaust air is set correctly if the powder does
not escape and is slightly removed.
– If necessary, adjust again on the appropriate pressure regulator
7. Coating can now commence
If an error message is displayed, correct the error and
acknowledge the error message so that the coating process
continues.
Screen selection
If the customer uses more than one screen, the OptiCenter panel displays
a relevant choice of mesh sizes.
Only previously configured mesh sizes are displayed, however.
– See chapter "Parameter description" on page 56.
1.
2.
The selected mesh size remains active until the system is switched on
again.
Manual coating
To Next Page
Loading...
