Gema OptiMove CR07 - Page 20

V 12/13
18 • Operating and display elements, operating modes OptiMove CR07
Display Meaning
A1
Actual value display (axis position)
Preset value input (position above, speed upwards, dwell time,
program address)
A2
Actual value display (axis speed)
Preset value input (position below, speed downwards)
A3
Displays the selected program number or the error code
Keys Meaning
Start axis (T7)
Stop axis (T8)
press for 5 seconds = system parameter
Start reference point travel (T9)
Input keys for preset values and system parameters (increase
value)
Input keys for preset values and system parameters (decrease
value)
T5, T6
Input keys for program number, error acknowledgment
Activate display mode (select desired value input LED 4 - LED
9)