V 12/13
OptiMove CR07 Operating and display elements, operating modes • 21
Keyboard lock
In the Keyboard lock operating mode, the control unit operating panel is
locked. The prerequisite for it is that the System parameter P9 must
already have been correctly set (P9=1, for more see "Setting the system
parameters“).
If the systems parameter P9=1 is set, the keyboard lock function can be
activated through the remote digital input. This is displayed on the
operating panel by lighting-up of the green Remote LED.
Only a limited operation is possible by the operating panel, namely:
- Start, stop, referencing axes
- Input mode/display mode selection (preset values and actual
values visualization)
- Error messages acknowledgement
To Next Page
Loading...
