V 12/13
30 • Operation OptiMove CR07
Edit programs
In the Edit program mode, the input parameter values can be selected or
changed.
NOTE!
All program data must be determined. Therefore, use the program
tables in the appendix of this operating manual!
The programs can be edited during operation and also at a standstill.
NOTE!
If the system parameter P2 is set to "2" or "4", editing is only
possible at a standstill!
In both cases the modifications are stored in the program memory, i.e.
after restarting the OptiMove CR07 Axis control unit, the last entered
program values are available again.
NOTE!
If a program is edited during operation, the axis terminates the old
command, which is still in the memory, and takes over the new
program values by the next cycle change!
NOTE!
The input mode is locked in Remote operating mode!
To Next Page
Loading...
