V 12/13
OptiMove CR07 Axes operating modes • 31
Axes operating modes
General information
The OptiMove CR07 Axis control unit is universally used for all Gema
axes. To be ideally equipped for all conditions, the operating mode can
be set in the system parameter mode P2. The following axes operating
modes can be selected:
- Pendulum operating mode
- Sequence program
- Semiautomatic pendulum operating mode
- X_GunClean sequence program
In the following chapter, the different axis operating modes are described
in detail.
Pendulum operating mode
In the pendulum operation mode, the axis executes a continuous stroke
movement according to the set parameters. With the keyboard, the
different values as well as the start and stop functions can be set in a
user-friendly way. The operator can read the set and current data directly
on the display. To be equipped for all operating processes, up to 255
different programs can be stored.
NOTE!
The system parameter P2 must be set on 1 (pendulum operating
mode)!
The equipment is operated by the operating panel. The following
possibilities are available:
- Referencing axes
- Start/Stop
- Edit programs
- Program change
- Select Input mode/display mode
- Acknowledgement of error messages
To Next Page
Loading...
