V 12/13
32 • Axes operating modes OptiMove CR07
Editing/setting
1. Select the desired program number using keys (see also
"Program change").
The display A3 shows the program number
2. Press the
key:
The LEDs in the display area A1 and A2 and the LEDs
and
illuminate green
3. Input the desired value for the upper reversing point on the
display A1 using the keys
4. Input the desired value for the lower reversing point on the
display A2 using the keys
NOTE!
If a same value is selected for the input of the upper and the lower
position, this results in a positioning command, i.e. the axis stops in
this position!
5. Press the key again:
LEDs
and illuminate green
6. Input the desired value for the speed upwards on the display A1
using the keys
7. Input the desired value for the speed downwards on the display
A2 using the keys
8. Press the
key again, or press or or , in order to exit
the Editing mode
Sequence program
A sequence program is created by joining a number of individual program
steps. The program steps are then processed in a certain order. A
sequence program can consist of a single program step, if only one
position is to be approached, e.g. when positioning the X axis.
NOTE!
The prerequisite for the programming of sequence programs is that
the system parameter P2 is already set correctly P2=2 (see also
"Setting the system parameters")!
To Next Page
Loading...
