Gema OptiMove CR07 - DigitalBus Parallel Interface

V 12/13
OptiMove CR07 Axes operating modes • 39
Name Default value
P5 - Open loop gain
40
P6 - Incremental pulse generator adjustment [pulse/cm]
750
P7 - Compensation of holding brake delay time [ms]
100
P8 - Communication
0
P9 - Keyboard lock
0
P10 - Referencing mode
0
P11 - CAN-Baud rate
3
P12 - CAN-Node ID
1
NOTE!
These default values are valid from software version V1.10!