Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Product description
11
Product description
Intended use
The Gun control unit is designed exclusively for controlling the Gema
powder coating guns and the OptiSpray AP01 application pump (see also
in chapter "Technical data").
Fig.
Up to 2 Application pumps can be controlled by this control unit:
– for supplying one powder gun with the powder (individual operation)
– to increase the supply rate (parallel operation).
The desired operation can be selected with the P09 system parameter
(see also "Entering the system parameters").
Usually, this control unit is used in automatic plants in connection with the
CM40 plant control. The real control of the application pump(s) as well as
the error messages display are done on the CM40, then. The cleaning
process too is initiated on the CM40.
Observance of the operating, service and maintenance instructions
specified by the manufacturer is also part of conformity of use. This
product should only be used, maintained and started up by trained
personnel, who are informed about and are familiar with the possible
hazards involved.
To Next Page
Loading...
