Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Product description
25
Cleaning mode
The Cleaning mode is used to blow powder accumulations out of the
powder hose, application pump, and gun using compressed air. A pinch
valve diagnostic is also integrated.
The cleaning mode can only be activated from standby mode,
namely by pressing the button on the gun remote control*.
– See chapter "Cleaning mode" on page 50.
* Disabled in network operation
The cleaning mode is signalized by a circling LCD segment on the
display:
Fig.
: Cleaning mode
The actual cleaning procedure is started and stopped by the
superordinated control unit.
Once the cleaning mode is quit, the unit automatically returns to the last
program.
To Next Page
Loading...
