Gema OptiStar 4.0 - Page 43

Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Operation

43
correct powder cloud
too little total air
Setting the powder output
1.
much powder
little powder
Adjust the powder output volume (e.g. according to the desired
coating thickness)
– Factory default setting of 50% is recommended for initial operation.
The total air volume is thereby kept constant automatically by
the control unit.
To achieve maximum efficiency, we recommend avoided an
overly high powder volume where possible!
2. Check fluidization of the powder in the powder container
3. Point the gun into the booth, switch the gun on and visually check
the powder output