Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Operation
51
Checking the software version
1. Press these two keys at the same time
– The status display is shown as long as the keys are held.
Checking the trigger time
1. Press these two keys at the same time
– The trigger counter (total time in days of trigger time) is shown in the
display (e.g. 35.5 days = 852 h).
The status display is shown as long as the keys are held.
The trigger counter can't be reset!
RAM Reset
The RAM reset enables a restore of factory settings of the gun control
unit. All parameters (except P00) and correction values as well as all
user-defined values in the Program mode and Preset mode will be
overwritten with factory default values. An active keyboard lock will be
deactivated.
By resetting the RAM, all user-made settings will be set to factory
default!
1. Switch off the device
2. Press the key and hold it
3. Switch on the control unit, the CLR display blinks
4. Wait for approximately 5 seconds until CLR disappears
To Next Page
Loading...
