Gembird NSW-R2 - User Manual

Need help?

Do you have a question about the Gembird NSW-R2 and is the answer not in the manual?

Summary

Chapter 2 Hardware Installation

2.1 Typical Installation

2.2 LED Indicators

Power LED

Run LED

WAN LED

LAN Link;Act LEDs (1-4)

Chapter 3 Network Setting and Software Installation

3.1 TCP;IP Configuration

3.2 IP Setting

3.3 Wizard Setup

3.5 WAN Setup

3.5.1 Dynamic IP

Configure DHCP for dynamic IP address assignment from ISP.

3.5.2 Static IP

Configure static IP address, subnet mask, and gateway provided by ISP.

3.5.3 PPPoE

Configure PPPoE connection with username and password from ISP.

3.6 LAN Setup

3.6.1 LAN Setting

Configure router's IP address, subnet mask, and DHCP server.

3.6.2 IP&MAC Address Binding

3.7 WLAN Setup

3.7.1 Basic Settings

Configure wireless band, SSID, and channel for the network.

3.7.2 Advanced Setup

3.7.3 Security

Configure wireless network encryption and authentication methods.

3.7.3.1 WEP

Set up WEP encryption for wireless security.

3.7.3.2 WPA;WPA2;Mixed

Set up WPA/WPA2 encryption for stronger wireless security.

3.7.4 Access Control

3.8 Security

3.8.1 Firewall

Configure firewall rules to protect the network from unauthorized access.

3.8.2 URL Control

3.8.2 Access Control

3.8.3 Block Port

3.8.4 Block Dos Attack

3.9 Services

3.9.1 Virtual Server

Set up port forwarding to allow external access to internal servers.

3.9.2 Special Application

Configure port triggering for applications requiring multiple connections.

3.9.3 DMZ

Configure a Demilitarized Zone (DMZ) for unrestricted host access.

3.10 Route Setup

Static Route

3.12 Resetting the Router