Gemini GEM-P9600 Programming Instructions

X
GEM-P9600 Programming Instructions
L
NAPCO Security Systems
WI777D 08/00
!
Page 74
KEYPAD CONFIGURATION MODE
GEM-RP1CAe2
KEYPADS
Press
A
button
Enter Factory Code:
11123
Configure:
•
Keypad Beep ON/OFF
• Entry Sounder
•
Keypad Address 01
• New Compat# 000 **
•
EZM Address 00
• Zone Response 00
•
Program Control Message# 1
Press
C
button
(“
01 OUT OF SYSTEM
”)
Return Jumper JP5 * from Pins 2-3 to Pins 1-2
(“
SYSTEM READY
”)
Move Jumper JP5 * from Pins 1-2 to Pins 2-3
(Wait about 15 seconds: “
OUT OF SYSTEM
”)
Configure:
•
Keypad Address (Jumpers J1-J3)
•
Touchpad Backlight (Jumper A)
•
LCD Backlight (Jumper B)
• Entry Sounder (Jumper C)
GEM-RP2ASe2
KEYPADS
* JP5 is located at the top-right corner of the circuit board.
** If a Compatibility Number other than “0000” is programmed, “
OLD COMPAT# XXXX
” is displayed.
Keypad Programming Modes: Keypad Configuration Mode
GEM-RP3DGTL
KEYPADS
Configure:
•
Keypad Address (Jumpers J1-J3)
•
Touchpad Backlight (Jumper A)
• Entry Sounder (Jumper C)
•
Enable Tamper LED (Jumper E)

Gemini GEM-P9600 Specifications

General

Brand	Gemini
Model	GEM-P9600
Category	Security System
Language	English