GETTING STARTED – BASIC USE
LRAD WIRELESS KIT
QUICK INSTALL GUIDE
1 (858) 676-1112 | www.genasys.com | info@genasys.com | P/N 119513-00 Rev. 03 | Copyright © 2021 Genasys Inc.
KIT CONTENTS
SETUP & CONNECTIONS
A. Connect receiver to LRAD. Connect audio cable from receiver to audio input connector on LRAD.
B. Attach receiver to LRAD using head unit mounting clip, located on top of the LRAD.
C. Connect headworn microphone to transmitter. Insert microphone cable into MIC audio input
connector.
AND/OR
D. Connect transmitter to external audio source (ex. MP3 player) using AUX cable. Insert one end of
the AUX cable into external audio device and the other end into AUX input connector.
1. Ensure that the Volume is Set to Minimum: Turn the Transmitter’s Volume Control Knob counter-clockwise prior to turning anything on (A).
2. Turn on Receiver and LRAD: Depending on the wireless kit and LRAD model being used, this will require turning on a Power Switch located on either
the LRAD or the Receiver (B).
3. Turn on the Transmitter: Press and hold the Transmitter’s Power Button (C).
4. Connect the Transmitter and the Receiver: Ensure that the transmitter’s channel matches that of the receiver.
5. Broadcast Audio through the Wireless Kit and LRAD: Adjust the Transmitter’s Volume Control Knob to reach the desired level (D).
Broadcast Spoken Audio: Press and hold the Push to Talk (PTT) Button and speak directly into the headworn microphone (E).
For continuous, hands-free transmission of spoken audio, pull the Locking Latch down onto the PTT button (F).
Broadcast a Pre-recorded Alert Tone: Press the Alert Tone Button (G).
Broadcast Audio from an External Audio Device: Initiate playback of audio on external audio device.
6. Power Down: First turn off the Transmitter by holding the Power Button, and then turn off the Receiver and the LRAD using the Power Switch.
Adjust volume carefully. Feedback can occur if
microphone is near the LRAD while operating at
high volume.
PTT Button does not need to be pressed to play
alert tone or audio from external audio device.
Audio from MIC and AUX inputs are mixed and
will broadcast simultaneously if audio is coming
from both inputs.
Never carry devices by the antenna or cable.
For more information consult the LRAD
Wireless Kit User Manual.
C
D
E
F G
A
B
2.
3.
4.
9.
5.
6.
7.
8.
10.
1. Wireless Receiver
2. Wireless Transmitter
3. Headworn Microphone
4. MP3 Player
5. Belt Pouch
6. AUX Cable (3.5 mm Audio Cable)
7. USB Cable
8. Wireless Microphone Package Manual
9. MP3 Player Instruction Manual
10. LRAD Wireless Kit User Manual
1.
To Next Page
General
