Installation Steps
14
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
(Continued)
Master Control
Touch Panel
Mounting Plate
and Control Cable
1. Open the shipping carton and locate the Master Control Touch Panel,
the Mounting Plate, and the 50-foot (15-meter) Control Cable in the top
portion of the shipping carton.
Figure 1 Locate the Master Control Touch Panel,
Mounting Plate, and Control Cable
2. Set the Master Control Touch Panel aside to be installed later.
Note! Before attaching the Mounting Plate, to ensure you orient the plate correctly,
take note of the two keyway studs at the top of the plate.
A
A
A
B
B
B
3. Refer to the supplied Mounting Template to select the mounting
location. Attach the Mounting Plate in the desired location with the three
supplied Phillips head screws and wall anchors at positions A. Or, the
three wood screws provided with the plate may be used to mount the
plate over a wood 2x4 stud at positions B.
Figure 2 Attach the Mounting Plate
(Continued)
To Next Page
Loading...
