Installation Steps
15
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
(Continued)
Note! In the following step, route the Control Cable in compliance with local
codes. The cable can also be run to an electrical box. If installing the
optional Wall Plate for mounting the Master Control, run the cable through
the opening at the top of the Wall Plate.
Once Master Control has
been mounted , the cable
extends past bottom
4. Fish the Control Cable from the Master Control Touch Panel to where
the Master Control will be located. Extend the cable out through the wall
to a length that will extend past the bottom front of the Master Control
(once mounted).
Figure 3 Fish the Control Cable from the Master Control
Touch Panel to the Location for Master Control
To Next Page
Loading...
