Installation Steps
17
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
(Continued)
Several possibilities exist for installing the Master Control:
• on a single wood wall stud (Configuration 1 - Mount to a single wood
wall stud, page 17)
• to 16 inch center studs (Configuration 2 - Mount to 16-inch center wood
wall studs, page 19)
• to a solid wall (Configuration 3 - Mount to a solid wall, page 21)
• into a pass-through (Configuration 4 - Mount in a pass-through box or
cabinet system, page 22)
• to a wall with steel studs (Configuration 5 - Mount to a wall with steel
studs, page 24)
Configuration 1 - Mount to a single wood wall stud
1. Determine the proper location for mounting the unit. Referring to the
Mounting Template, verify that each electrical box is positioned
correctly in relation to location of the mounting stud.
2. Position the template or the Master Control itself at the appropriate
height. Mark the wall for the mounting holes.
Note! If using the Master Control for marking, lay the unit aside before continuing.
3. Drill pilot holes for the mounting bolts. Remove the Mounting Template
(if used).
4. Route the power supply wires and, if used, the Control Cable from the
Master Control Touch Panel, into the Master Control.
(Continued)
To Next Page
Loading...
