NOTE 2
NOTE 3
NOTE 1
NOTE 1
NOTE 1
NOTE 1
NOTE 5
NOTE 2
NOTE 4
NOTE 4
NOTE 3
MOUNTING WITH D800WP
SPECIAL 16" CENTER WALL PLATE
NOTE 1:
HOLE LOCATION TO MOUNT THE WALL PLATE VIA LAG BOLTS (SUPPLIED) TO WOODEN WALL STUDS SPACED AT 16" (40.6cm). MAXIMUM BOLT DIAMETER IS 10mm OR 3/8". BEFORE MOUNTING, VERIFY THAT WALL SUPPORT AND HARDWARE
MEET THE SUPPORT REQUIREMENTS LISTED ON THE OTHER SIDE.
NOTE 2:
THREADED HOLES TO MOUNT MASTER CONTROL BOX TO WALL PLATE WITH BOLTS SUPPLIED WITH WALL PLATE.
NOTE 3:
ELECTRICAL POWER ENTRY POINT. UNIT MUST BE CONNECTED TO ELECTRICIAN SUPPLIED POWER PER THE REQUIREMENTS LISTED ON THE OTHER SIDE. JUNCTION BOX POSITION SHOWN.
NOTE 4:
ENTRY POINT FOR THE INTERCONNECTING CABLE USED WHEN REMOTELY MOUNTING THE OPERATOR CONTROL PANEL. JUNCTION BOX POSITION SHOWN.
NOTE 5:
ALTERNATIVE ENTRY POINT FOR THE INTERCONNECTING CABLE USED WHEN REMOTELY MOUNTING THE OPERATOR CONTROL PANEL.
Installation Steps
20
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
4. Using the mounting bolts supplied with the Wall Plate option, start the
top two mounting bolts. Do not tighten.
Figure 8 Start the Top Two Mounting Bolts
5. Verify the level of the Wall Plate and start the lower two mounting bolts.
Once the level of the Wall Plate is set correctly, tighten all mounting
bolts.
6. Route the power supply wires and, if used, the Control Cable from the
Master Control Touch Panel, into the Master Control.
7. Place the Master Control into position and start the upper mounting bolt.
Do not tighten.
Figure 9 Start the Upper Mounting Bolt
8. To complete installation for the Master Control, go to Final Steps to
Install Master Control starting on page 25.
To Next Page
Loading...
