Installation Steps
22
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
Configuration 4 - Mount in a pass-through box or cabinet system
Not included in shipping carton:
Mounting bolts appropriate for the pass-through box or cabinet sys-
tem
Note! Care must also be taken to properly locate the power supply and/or Operator
Panel junction boxes.
Mounting requirements and locations vary by the manufacturer of the pass-
through box or cabinet system. Some are pre-drilled while others require
marking and drilling for the mounting bolts. Refer to the manufacturer for
specifics. In many cases, the Master Control can be mounted as if it is being
mounted to a single stud. Other cases may require the optional Wall Mount
Back Plate (215-0148P1).
1. Determine the proper location for mounting the unit.
2. If pre-drilled holes are not present, drill the holes for mounting the
Master Control or the Wall Mount Back Plate.
3. If mounting the Wall Mount Back Plate, follow the instructions
provided with the Wall Mount Back Plate. Otherwise continue to the
next step.
4. Route the power supply wires and, if used, the Control Cable from the
Master Control Touch Panel, into the Master Control.
(Continued)
To Next Page
Loading...
