Installation Steps
24
Document No. PEXPERTIM - Rev. 1 - Release Date: May 2007
Configuration 5 - Mount to a wall with steel studs
Note! Requires the optional Wall Plate (D800WPEXPERT) and the Backing Plate
(D800BPEXPERT).
This configuration requires drilling through the wall and capturing two steel
studs between two plates: the front Wall Plate and the Backing Plate (located
on the other side of the wall).
Note! Verifying the wall support capability is the responsibility of the installer.
1. Follow the instructions provided with the Backing Plate option to install
both plates.
2. Route the power supply wires and, if used, the Control Cable from the
Master Control Touch Panel, into the Master Control.
3. Place the Master Control into position and start the upper mounting bolt.
Do not tighten.
Figure 12 Start the Upper Mounting Bolt
4. To complete installation for the Master Control, go to Final Steps to
Install Master Control starting on page 25.
To Next Page
Loading...
