21
Operator’s Manual 032-0176-EN Rev. 4
General Operating
Procedures
8.1 Equipment preparation
Turn the system on by means of the power on/off switch located on the oor portion of the
mounting xture, at the base of the column. The “power on” lamp on the column control panel will
light up, as will lamp for patient size currently selected and the mA and kV displays.
Note: It is neither necessary nor advisable to turn the unit off between use by means of the
power on/off switch. The unit has a built-in “sleep” mode, which will shut the system down
after approximately 30 minutes to minimize power use.
8
Power Switch
To Next Page
Loading...
