Genelec 7071A - Page 2

7060A-7070A-7071A
Quick setup guide
Connection to the 6.1 bass management
Phase alignment
REDIRECT
SUM IN MODE
LFE BANDWIDTH
120
85
TEST TONE
ON
LFE + 10 dB
REDIRECT
SUM IN MODE
LFE BANDWIDTH
120
85
TEST TONE
ON
LFE + 10 dB
REDIRECT
SUM IN MODE
LFE BANDWIDTH
120
85
TEST TONE
ON
LFE + 10 dB
LFE reproduced full range
LFE reproduced up to 85 Hz LFE reproduced up to 120 Hz
Subwoofer
Subwoofer
Subwoofer
85 Hz
85 Hz
120 Hz
1. Switch on the test tone
by setting dip switches 3
and 4 on the left switch
group to on. An 85 Hz
signal should be heard
from the subwoofer and
the monitor connected
to FRONT CENTER
channel.
5. Switch off the test tone.
Be sure to turn off both
switches to disable the test
tone.
Optional
slave subwoofer
SUM IN
input only
REDIRECT
SUM IN MODE
LFE BANDWIDTH
120
85
TEST TONE
ON
LFE + 10 dB
ROLL-OFF
-4 dB
-2 dB
ON
PHASE
0/-180 DEG
0/-90 DEG
ROLL-OFF
-4 dB
-2 dB
ON
PHASE
0/-180 DEG
0/-90 DEG
ROLL-OFF
-4 dB
-2 dB
ON
PHASE
0/-180 DEG
0/-90 DEG
REDIRECT
SUM IN MODE
LFE BANDWIDTH
120
85
TEST TONE
ON
LFE + 10 dB
2. Toggle the sub-
woofers dip switch 4 on
the right switch group
on and off and set it
to the position which
gives the lowest sound
level at the listening
position.
3. Toggle the sub-
woofers dip switch 3 on
the right switch group
on and off and set it
to the position which
gives the lowest sound
level at the listening
position.
4. Set dip switch 4 to
the opposite setting.
L
C
R
SL SC SR
LFE
GENELEC
OVL
ON
GENELEC
OVL
ON
GENELEC
OVL
ON
GENELEC
OVL
ON
GENELEC
OVL
ON
GENELEC
OVL
ON
Setting the LFE channel reproduction bandwidth
Center speaker
redirect on
Genelec Document BBAQSLSE001. Copyright Genelec Oy 2.2003. All data subject to change.
GENELEC