Generac 2700PSI High Pressure Washer
GENERAC
The Reliable Ones
9
ASSEMBLY
WARNING! Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
Attach dual lance to spray gun. Tighten by hand
(Figure 9).
CHECKLIST BEFORE
STARTING ENGINE
If you have reached this point, look back over the
assembly to see if you have performed all of the
following.
Check for properly tightened hose connections
(high pressure and water supply) and for tight
connections and that there are no kinks, cuts, or
damage to the high pressure hose, or garden hose.
Check that oil has been added to proper level in
engine crankcase before trying to start the pressure
washer.
Add proper gasoline to fuel tank.
Provide proper water supply (not to exceed 140°F).
Be sure to read Safety Rules and Operation
sections before using the pressure washer.
Figure 9 — Connect nozzle extension to spray
gun.
To Next Page
Loading...
