Generac Portable Products 2,100 PSI High Pressure Washer
11
Pressure Washer Rinsing
WARNING: Be extremely careful if you must
use the pressure washer from a ladder,
scaffolding or any other relatively unstable
location. Pressure in a running washer builds
as you climb. When you press the trigger, the
recoil from the initial spray could cause you to
fall. The high pressure spray could also cause
you to fall if you are too close to the cleaning
surface.
For Rinsing:
Slide the nozzle backward to high pressure, press
the trigger and wait for the detergent to clear.
NOTE: You can also stop detergent from flowing by
simply removing detergent siphon tube from bottle.
Keep the spray gun a safe distance from the area
you plan to spray.
Apply a high pressure spray to a small area, then
check the surface for damage. If no damage is
found, it is okay to continue cleaning.
Start at the top of the area to be rinsed, working
down with same overlapping strokes as you used for
washing and applying detergent.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach a
temperature between 140145°F. When the water
reaches this temperature, the automatic cool down
system engages and cools the pump by discharging
the warm water onto the ground. This system
prevents internal damage to the pump.
SPECIFICATIONS
Outlet Pressure . . . . 2,100 psi
Flow Rate . . . . . . . . . 2.0 gallons per minute (gpm)
Detergent . . . . . . . . . Use detergent approved for
pressure washers
Water Supply Temp . Not to Exceed 140°F
Automatic Cool . . . . Will cycle when water
Down System . . . . . . reaches 140°-145°F
To Next Page
Loading...
Need help?
General
