Operation
14 Owner’s Manual for 60 Hz Synergy™ Generators
Menu System Navigation
To get to the MENU, use the ESCAPE button from any page. You may need to press the ESCAPE button several times
before reaching the MENU page. Navigate to the desired menu by using the
↑/↓ buttons. When the desired menu is
displayed and flashing, press the ENTER button.
Figure 3-6. Navigation Menu
SYNERGY HSB MENU MAP
“Run Log”
ESC
ENTER
ENTER
SYSTEM
B
TTER
HISTOR
EDIT
Exercise Time
Å
14:00 Wednesday
Æ
Firmware Update
Å
Press Enter
Æ
ESC
Current Date/Time
Å
2/12/13 12:22
Æ
ESC
ENTER
ENTER
ESC
ESC
ESC
ESC
ENTER
ENTER
ESC
ESC
ENTER
ENTER
ESC
ENTER
ENTERENTER
ENTER
ENTER
ENTER
ENTER
ESC
Switched to “OFF”
Hours of Protection
0 (H)
Language
Å
English
Æ
Fuel Selection
Å
NG or
P
Æ
Firmware Update
Å
Insert USB
Æ
“Alarm Log”
-
larm Log +
- Run Log +
- 1 thru 50 +
- 1 thru 50 +
Running Manual
Running-Utility Lost
Running-Remote Start
Running-2 Wire Start
Running - Exercise
Switched Off
Stopped -
uto
Stopped -
larm
ESC
Select Min (0-59)
- 0 +
ESC
ESC
Select Hour (0-23)
- 14 +
ESC ESC
Quiet Test Mode ?
- YES or NO +
Select Frequency
- WEEK
+
- BIWEEK
+
- MONTHL
+
Quiet Test Mode only on
certain models
Language
+ English -
Fuel Selection
+ NG or
P -
Language
+ Espanol -
+
-
+
-
Battery Condition
“Good” “Inspect Battery” or “Check Battery”
*“Fuse Problem” on
Firmware 1.11 and older
ON
Note: Menu functions and features may vary depending
on unit model and firmware revision.
003634a
Warning Message(s)
"Low Battery"
"Exercise Set Error"
"FIRMWARE ERROR-9"
"Fuel Pressure"
"Battery Problem"
"Charger Warning"
"Charger Missing AC"
"Overload Warning"
"Overload Cooldown"
"SEEPROM ABUSE"
"USB Warning"
"Download Failure"
Alarm Message(s)
"High Engine Temp."
"Low Oil Pressure"
"Overcrank"
"Overspeed"
"RPM Sense Loss"
"Underspeed"
"Internal Fault"
"FIRMWARE ERROR-7"
"WIRING ERROR"
"Over Voltage"
"Under Voltage"
"Overload Remove Load"
"Low Volts Remove Load"
"Stepper Over Current"
"Fuse Problem"
To Next Page
Loading...
