EasyManuals Logo

Generac Power Systems 2000PSI User Manual

Generac Power Systems 2000PSI
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Generac 2000PSI High Pressure Washer
GENERAC
The Reliable Ones
15
PREPARING THE UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and freeze pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1.Flush chemical injection tube by placing the injector
filter into a pail of clean water while running
pressure washer and squeezing the spray gun
trigger with the adjustable nozzle in low pressure
mode. Flush for 12 minutes.
2.Shut off the engine and let it cool, then remove all
hoses.
3.Place throttle lever in STOP position.
CAUTION! Be sure lever is in STOP
position before you continue. If you start
engine without proper water supply connected,
you can damage pump.
4.Empty the pump of all pumped liquids by pulling
recoil handle about 6 times. This should remove
most of the liquid in the pump.
NOTE: To protect unit from freezing temperatures,
draw windshield washer fluid into pump by pouring
RV antifreeze (antifreeze without alcohol) into a
3foot section of garden hose connected to inlet
adapter and pulling recoil handle twice.
5.Store in a clean, dry area.
STORING THE ENGINE
See the Engine Owners Manual for instructions on
how to properly store the engine.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Generac Power Systems 2000PSI and is the answer not in the manual?

Generac Power Systems 2000PSI Specifications

General IconGeneral
BrandGenerac Power Systems
Model2000PSI
CategoryPressure Washer
LanguageEnglish

Related product manuals