To Next PageTo Next Page
Need help?Do you have a question about the General Pipe Cleaners Gen-Eye POD and is the answer not in the manual?
General| Brand | General Pipe Cleaners |
|---|---|
| Model | Gen-Eye POD |
| Category | Analytical Instruments |
| Language | English |
Keep work area clean, well-lit, and free from hazards to prevent accidents.
Ensure proper grounding, avoid wet conditions, and handle cords carefully to prevent shock.
Stay alert, dress properly, maintain balance, and use safety equipment for protection.
Use correct tools, disconnect power for adjustments, store safely, and inspect for damage.
Ensure qualified personnel perform service and use identical replacement parts.
Symbol alerts users to potential personal injury hazards. Obey all safety messages.
Improperly wired outlets can cause electrocution. Use a tester for safety.
Always wear safety glasses and non-slip shoes to prevent serious injury.
Wear rubber gloves due to unsanitary conditions and potential bacteria.
Ensure proper grounding and use appropriate heavy-duty extension cords.
Avoid contact with drain cleaners and do not operate in water.
Use the tool only for its intended application to avoid increased risk.
Do not use the POD in wet locations or rain due to moisture damage risk.
Operates on 120vAC/12vDC; ensure proper grounding for 120vAC.
Do not operate if malfunctioning; call the factory for service.
Treat camera carefully; clean and inspect after use to prevent damage.
Avoid excessive bending or twisting of the transmitter in the spring.
Position POD viewably, check receptacle, and ensure proper orientation.
Set light head intensity control to the 'low' position initially.
Plug AC cord into POD first, then into a properly grounded receptacle.
Plug DC cord into POD first, then into a 12vDC source with engine running.
Ensure the power switch on the LCD monitor is turned on.
Release latch, open lid as sun shield, and adjust monitor angle via gooseneck.
Release locking pin and drag brake, then slowly push camera without kinking.
Adjust lights for best picture; fine-tune brightness and contrast.
Plug an external recording device into the VIDEO OUT connection.
Turn the POD on to activate the transmitter automatically.
Turn Locator on, check battery, and set frequency to match transmitter.
Press ANT SEL to point the indicator arrow to TWIN PEAK.
Press UP arrow to set gain bar to maximum, then adjust as needed.
Rest locator vertically above pinpointed position and press DEPTH button.
Press DEPTH and DOWN buttons simultaneously to select units (feet, meters).
Clean camera lens with soft cloth; use non-ammonia cleaner for monitor.
LED lights are not operator replaceable; return camera for service if damaged.
Keep cable and reel clean; wipe off debris. Do not use a pressure washer.
Camera and electronics are not user serviceable; consult dealer for service.
Cameras are factory pre-focused; call factory for focus adjustments.
Protect unit from excessive shock and jarring to prolong its life.
Controls light output and intensity on the camera light head.
Check power, monitor button, connections, and lens obstruction.
Check light intensity, push rod for breaks, or consider light replacement.
Check monitor switch, AV input, brightness/contrast, and push rod integrity.
Use Menu button to select UP or LEFT arrows to invert/reverse picture.
Check brightness, contrast, light head output, and intensity control.
Check remote batteries, installation, and sensor lens for proper function.
Check camera lens, light head, external noise, and push rod integrity.
Two-year warranty against defects; excludes damage from negligence or misuse.
Follow procedure with wholesaler, providing serial number and purchase details.
Excludes incidental/consequential damages; state laws may vary.
