5. Attach the front and rear top shelves as shown
using 4 carriage bolts, flat washers and hex nuts for
each cross brace.
6. Attach the two side top shelves as shown using
4 carriage bolts, flat washers and hex nuts for each
cross brace.
ASSEMBLE THE SAW
With the help of an assistant lift the saw onto the stand (or
your own stand if the unit was special ordered without the
stock stand).
Using a 13 mm wrench & socket, secure the saw to the
stand with the supplied bolts, nuts and washers in the
order shown.
THIS TABLE SAW IS HEAVY. SEEK ASSISTANCE WHEN LIFTING
IT ONTO THE STAND.
Install the fence storage brackets to the saw as shown. Install the miter gauge storage brackets to the saw as
shown.
Install the blade height adjustment hand wheel as
shown.
Install the blade tilting hand wheel as shown.
12
To Next Page
Loading...
