1. Place a straightedge against a front and back tooth
of the blade C. There should be a more or less equal
gap between the straightedge and the splitter/riving
knife on both sides of the blade D.
2. The splitter/knife mounting bracket assembly is held
together by two button head locking screws E. Both
90º to the table and parallel/centered to the blade
alignments can be achieved by adjusting the four
set screws F. The locking screws must first be loo-
sened (using a 3mm allen key) – 1/4 turn or more,
depending upon how much adjustment is re-
quired, in order to be able to adjust the set screws F
using a 2.5 mm allen key.
REMOVE/INSTALL THE BLADE COVER
1. Disconnect the machine from the power source.
2. Loosen the Knob, A, on the top of the cover.
3. Pull back 1 and lift 2 the cover body until it can be
removed from the splitter.
A
1
2
CENTERING THE SPLITTER / RIVING KNIFE ON THE BLADE
The splitter/riving knife should be more or less centered on
the blade to allow for workpiece clearance on both sides
of the blade A.
THE SPLITTER/RIVING KNIFE SHOULD NEVER PROTRUDE
BEYOND EITHER EDGE OF THE BLADE
B
.
THIS WILL OBS-
T
RUCT THE WORKPIECE AND LEAD TO A DANGEROUS
K
ICKBACK SITUATION WHICH CAN LEAD TO SERIOUS
PERSONAL INJURY.
16
REMOVAL/INSTALLATION
Set the blade to 90º and raise it to its highest position and
remove the table insert. If already installed, remove the
splitter or riving knife by loosening the lock knob A and
pulling the splitter or riving knife up out of its mounting
b
racket.
To install, fit the bottom end of the splitter or riving knife
i
nto the slot in the mounting bracket and tighten the lock
knob to lock it in place. Re-install the table insert.
A
LEFT SIDE
RIGHT SIDE
C
D
D
F
E
LARGER VIEW
TOP VIEW
Riving Knife
Blade
Table insert
DON’T
B
A
REMOVE
To Next Page
Loading...
