13
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE DUST OUTLET AND CONNECTING THE INTERNAL HOSE
1. Remove the 3 nylock nuts from the dust outlet, leav-
ing the bolts in place.
3. Insert the bolts into the holes in the bottom of the
cabinet.
2. Remove the hose clamp.
4. Secure the outlet from inside the cabinet by using
three nylock nuts with a 10 mm wrench.
INSTALLING THE SAFETY STOP SWITCH
1. Install the switch on the front support by aligning its
mounting screws with the corresponding holes in
the support.
2. Secure the switch to its support by tightening the
four screws with a Phillips screwdriver.
To Next Page
Loading...
