15
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE REAR AUXILIARY TABLE
1. Set the auxiliary table upside down and align the
support legs mounting holes with the correspond-
ing holes in the table.
3. Remove the top screw from the supplied threaded rod.
5. Screw the assembly (screw + flange) into the thread-
ed rod as shown.
6. Screw the rod into the support leg. Repeat for the
other leg.
4. Insert the screw into the flange as shown.
2. Using a 12 mm wrench, secure each leg to the ta-
ble with 2 bolts, lock washers and flat washers A.
A
To Next Page
Loading...
