16
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING THE REAR AUXILIARY TABLE (CONTINUED)
7. Secure each flange to its rod using a Phillips screw-
driver.
8. Measure the distance from the top of the table ex-
ention to the ground, then measure the distance
from the ground to the flange.
9. Turn the rod to adjust its height so that the distance
from the ground to the flange is about the same as
the distance from the ground to the top of the table
extension. Repeat with the other leg.
10. With the help of an assistant, align the auxiliary ta-
ble mounting holes with the corresponding holes in
the table extension.
11. Loosely attach the auxiliary table with a cap screws,
lock washers and flat washers A.
12. Place a straight edge across the table extension
and the auxiliary table and turn the leg rod until the
auxiliary table is level with the table extension. Re-
peat to adjust the other leg.
A
To Next Page
Loading...
