20
INSTALLING THE RIP FENCE (CONTINUED)
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
16. While holding nut A with a 19 mm wrench, tighten
the nut under the table with another 19 mm wrench
to hold the rail in place. Repeat with the other two
nuts.
15. Once nut A in the previous step has been adjusted,
turn nuts B against the table edges.
Note: The nuts B have to just touch the table edges (without
pressure) to maintain the fence face flush with the main
table T-slot.
B B
17. Unlock the fence and position it flush with the blade.
Note: To install a main blade, see section "Installing blades".
18. Using a marker, extend the line from the pointer
onto the fence rail.
19. Remove fence face from the fence body then re-
move the fence body.
20. Clean the slot in the rail to remove any lubricant.
Use an appropriate solvant if needed.
A
To Next Page
Loading...
