23
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS UN-
PLUGGED. DO NOT PLUG IN OR TURN ON THE SAW UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND INSTALLATION
STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
INSTALLING A MAIN BLADE (OPTIONAL)
1. Pull back the sliding table lock lever and slide the
table to the right.
3. Repeat step 2 with the cap screw at the other end.
5. Remove the table insert. 6. Remove the arbor nut by turning it clockwise, then
remove the flange.
4. Flip open the lower blade guard as shown.
2. Unscrew the lower blade guard cap screw using a
5 mm Allen key.
This saw is intended for use with 10” (254 mm) diameter or less saw blades having a center hole
diameter of 5/8”. There are many types of blades available to perform specific cutting jobs, such
as crosscuts or ripping only, or for use with plywood, panelling and other products. A good quality
specialty blade can produce a finer finish, be more efficient and place less strain on the saw. Use
only saw blades designed for operating speeds of 4200 rpm or higher. Saw blades should be kept clean
and sharp. Never store saw blades by stacking them directly in contact with each other. Place a layer of
cardboard or similar material between the blades to keep them from coming into contact with each other.
To Next Page
Loading...
