EasyManua.ls Logo

General ASWA09JEC - Page 19

General ASWA09JEC
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
En-4
Fig. 6 Remote Control Unit
K Signal Transmitter
L MODE button
M SLEEP button
N TIMER MODE button
O FAN button
P START/STOP button
Q SET TEMP. button (
/ )
R SET button
S SWING button
T TIMER SET (
/ ) button
U CLOCK ADJUST button
V TEST RUN button
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
W RESET button
X Remote Control Unit Display (Fig. 7)
Y Transmit Indicator
Z Temperature SET Display
[ Fan Speed Display
\ Operating Mode Display
] SWING Display
` SLEEP Display
a Timer Mode Display
b Clock Display
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
When the forced cooling operation starts
by any chance, press the START/STOP but-
ton to stop the operation.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (green)
6 TIMER Indicator Lamp (orange)
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 14 Auto Restart).
7 SUPER QUIET Indicator Lamp (yellow)
8 Intake Grille (Fig. 4)
9 Front Panel
0 Air Filter
A Air Flow Direction Louver
B Right-Left Louver
(behind Air Flow Direction Louver)
C Drain Hose
D Power Supply Plug
E Power Supply Cord
F Air Cleaning Filter
Fig. 5 Outdoor Unit
G Intake Port
H Outlet Port
I Pipe Unit
J Drain port (bottom)
08J338_9317433006-01_En_body 2008.10.13, 10:30 AM4

Related product manuals