2-27
02
Pay extreme caution not to dam-
age the connectors, while remov-
ing the head restraint. Damage to
the connectors may cause a tech-
nical problem.
Folding the center head restraint 
(if equipped)
To fold the center head restraint :
• When the rear-center head
restraint is not used, manually fold
back the rear-center head restraint
while pressing the button (1) on the
side. To use the rear-center head
restraint again, manually pull up
the rear-center head restraint, until
it is securely latched.
• You can remove the rear-center
head restraint by manually pulling
up the rear-center head restraint,
while pressing the release button.
Information 
You can adjust the rear-center head
restraint to the further lower height
by pressing the button (2), which is
located under the rear-center head
restraint, with the armrest folded
back. 
If the center head restraint is in
the lowest position, raise the head
restraint before folding back the
armrest.
NOTICE
i
NOTICE
OHI036130
When the center head restraint
is not in use, fold the head
restraint  back to prevent it from
interfering with your vision
through the rear window.
CAUTION