6.4 Scuba Diving Settings
Fig#25
Set Gas
PATH: Menu > [Down Button] Settings > Set Dive > Scuba > Set Gas
Gas Setting Fig#26
Once this option is selected, the first line will show 21% FLASHING,
press the Up/Down arrow keys to select different values & then
the Mode Selector button to confirm the setting, and pass to the
next setting. The PO2 value 1.4 will now be FLASHING now,
change the values with the Up/Down buttons & accept the
selection pressing the Mode Selector button once until the
selection stops flashing. NOTE: The MOD value will change
automatically based on the gas O2% & PO2 selections.
Notes:
1. Change this O2 value until you had personally confirmed via
oximeter that oxygen % of the cylinder you are using has the exact
same value you are entering in your Graviton.
2. Do not use Nitrox if you’ve not received the proper training first
& fully understand the risk of CNS Oxygen Toxicity associated with
the use of gas blends different than breathing air.
Set Gas
MOD
21
O %
2
184
1.4
ft
PO2
%
To Next Page
Loading...