Genesis GV70 2024 - Page 27

HOMELINK WIRELESS GARAGE CONTROL SYSTEM
25
Quick Reference Guide
I
GENESIS GV70
STEP 1: Press and release button , , or .
• If the indicator illuminates and shows light, ORANGE
go to Step 3 - Programming Mode.
• If the indicator illuminates and shows a solid or flashing
GREEN light, go to Step 2 - Erasing Mode).
STEP 2: Erasing Mode - Press and hold the button you wish to
program for approximately 15-25 seconds until the LED flashes
in for several times.ORANGE
STEP 3: Programming Mode - While the HomeLink indicator light is
flashing , press and hold the handheld remote button ORANGE
until the HomeLink indicator light changes from to ORANGE
GREEN. You may now release the handheld remote button.
STEP 4: Wait until your garage door comes to a complete stop,
regardless of position, before proceeding to the next steps.
STEP 5: Press and release the HomeLink button you are programming
and observe the indicator light:
• If the indicator light remains , your device solid GREEN
should operate when the HomeLink button is pressed. At this
point, if your device operates, programming is complete.
• If the indicator light , firmly press, rapidly flashes GREEN
hold for 2 seconds and release the HomeLink button up to
three times in a row slowly to complete the programming
process. Do not press the HomeLink button rapidly. At this
point if your device operates, programming is complete. If
the device does not operate, continue with step 6.
1
11
1
11
1
11
1
3
1
3
1
3
1
4
1
4
2
2
2
5
5
6
6
7
7
7
7
7
7
7
7
HomeLink Channels: 1 / 2 / 3
Garage Door Opener Status Indicator: Closing or Closed
HomeLink Operation Indicator
HomeLink User Interface Indicator