Genesis Prana Regulator GR910 - Initial Set-Up and Pre-Dive Checks; Accessory Installation Guidance; Pre-Dive Inspection Procedure

WWW.GENESISSCUBA.COM
10
INITIAL SET UP
Your Prana regulator provides options for the attachment of accessories such as the
and the alternate air source (Prana Octo).
Genesis recommends that you consult your Authorized Genesis Dealer to install these
accessories for you.
BEFORE THE DIVE
It is important to inspect the regulator before starting your dive trip and again just before you
enter the water. The pre-dive check should consist of at least the following steps.
1. Carefully inspect all hoses for signs of damage. This may require you to retract the
hose
protectors at the ends of the hoses to examine the hose condition near the
end
before you dive.
2. Visually inspect the entire regulator for signs of damage. If in doubt ask y
our
Authorized Genesis Dealer to assist you in performing this examination.
3. Connect the regulator to a pressurized cylinder and press the purge button sever
al
minimal. If there is an unusual breathing resistance, have your regulator checked by a
professional instructor or by your Authorized Genesis Dealer before attempting to
enter the water.
Genesis