Genie Z Series User Manual

Maintenance Manual April 2018
Programmed Maintenance Procedures
134 S
®
Booms • Z
®
Booms Part No. 1268489GT
P0-6
Deutz Engine Maintenance – Under 1000 Hours
Additional engine maintenance is required. Refer to the Programmed Maintenance Inspection Report for
the specific intervals that apply.
Required maintenance procedures and additional engine information are available in the manufacturer's
manuals. Refer to Specifications, Engine Operator and Maintenance Manuals.
This maintenance schedule applies to the following Deutz Engines:
D2011 L03i TD2011 L04i D 2.9 L4 TD 2.9 L4 D436 L3i CN3
Deutz Engines Hour Intervals
Procedure
∅ =
Not required
Daily 250 500
Oil level - check
∅ ∅
Coolant level - check
∅ ∅
Oil, fuel and coolant systems - check for leaks
∅ ∅
Fuel system filter/water separator – inspect/drain
∅ ∅
Air filter discharge valve - clean
∅ ∅
Exhaust system - inspect
∅ ∅
Check / clean the oil cooler and cooling fins - Deutz D2011 and D436 Models
∅ ∅
Engine oil and filter – replace
∅ ∅
Air filter - replace
∅ ∅
Valve clearance - check/adjust
∅ ∅
Engine coolant - test/add
∅ ∅
Air intake pipes - inspect
∅ ∅
V-belts - inspect
∅ ∅
Fuel filter / separator - replace
∅ ∅

Genie Z Series Specifications

General

Lift Capacity	500 lb (227 kg) to 660 lb (300 kg)
Gradeability	30%
Power Source	Diesel, Electric
Capacity	500 lb (227 kg) to 1, 000 lb (454 kg)
Drive System	4-wheel drive
Tire Type	Solid
Steering	2-wheel or 4-wheel