ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
28
Genius Car Alarms
www.alarmasgenius.com
Functions Remote Control 4 Button GENIUS
Button Function Terms
Arm Disarmed
Car Finder Armed
Button 1
Lock Ignition ON / Valet Mode
Disarm Alarm armed Button 2
Unlock Ignition ON / Valet Mode
Button 3, then button 1 Silent arms Disarmed
Button 3, then button 2 Silent Disarm Armed
Buttons 1 and 2 for 3 seconds Function Panic Armed or Desarmed
Button 4 for 3 seconds Channel 2 Forever
Buttons 3 and 4 for 3 seconds Channel 3 Forever
Button 1, then button 2 Shock Sensor Bypass Disarmed
Button 4 for 3 seconds Anti-hijacking Ignition ON
NOTE: Please review the table above and follow the instructions for the functions.
Learning Remotes (Genius) and Transmitter Presence. (Genius)
The alarm system is designed to learn up to 4 different remote controls, caution when
programming the first remote control alarm system erases memory previous remotes Genius.
program all remotes at the same time, because by this you erase function can erase any memory
of the remote control is lost is simply programmed the remote or remotes you own again. The
transmitter presence should be the last program.
Learning remotes (Genius), follow these steps:
1. With the system disarmed alarm, switch ignition to the ON position
2. Within the first 5 seconds after the last swiche ignition to the ON position, press and release
the reset button 5 times, the siren will confirm with a long sound, you have 10 seconds to
begin entering the remotes, if not enter any remote before the 10 seconds or passes
swiche ignition to the OFF position, the system will exit the learning mode and remote
controls will confirm with 2 siren sounds and the memory of the remote control will not be
removed.
3. Press and release the remote control button 1 to program the siren sound will confirm the
learner's with 1 remote control, at this time the old remotes are erased.
4. To program a second remote control repeat step 3 where the siren will confirm with 2
sounds the learner's second remote control with 3 sounds and the third to the fourth remote
control programming closes.
5. Pass the ignition to OFF or wait 10 seconds, the alarm system closes and exits the learning
mode of remote controls, siren with 2 sounds confirmed.
6. If the anti-hijacking ignition is on, place the system in valet mode and follow steps 1 to 5.
7. To program additional transmitter anti-hijacking presence, in the first program memory
remotes alarm and finally program the additional presence transmitter. With the presence
transmitter off, press and release the transmitter button, the system will confirm with various
sounds memorization transmitter
To Next Page
Loading...