32
EN
SETTING A BLADE TILT POSITION
Set up the rotating laser to the required height.
Connect the receiver to the mast.
Tilt the blade left / right until required position is reached.
Power On the receiver.
Press the „bulldozer - mode“ button.
The „bulldozer - mode“ is now activated.
Press Power On/Off button and accuracy button
simultaneously until the green LED‘s are
flashing.
Remark
The new blade tilt position is memorised,
even when the receiver is powered Off.
To re-set the receiver/blade to on-level pro-
ceed as described below.
RESET BLADE TILT POSITION TO ON-LEVEL
Level the blade by using a spirit level.
Set this position as described above.
To Next Page
Loading...