NO.
1
2
3
SERVICE
Wheel Bearings Inspection
-
Inspect every
15
months, or at
15,000
mile
(25
OOO
km)
intervals.
Inspect for wear and proper adjustment. Relubricate
the bearings
if
grease is contaminated.
Propeller Shafts and U-Joints
Inspection
-
Inspect for looseness and damage.
Do
this every
15
months, or at
15,000
mile
(25
000
km)
intervals, or more frequently
if
used off-road or
pulling a trailer. Tighten U-Joint flange bolts if
necessary.
Clutch (Manual Transmission Only)
-
At
each
oil
change, inspect for correct free play and positive
engagement. See “Clutch Adjustment’’
in
the Index.
Maintenance Schedule
Uther Nun-Emissun Related Maintenance
Service
ITEM
4
Tire and Wheel Inspection and Rotation
-
For
proper wear and maximum tire life, rotate your tires
at
7,500
miles
(12
500
km)
and
then
every
15
,OOO
miles
(25
OOO
km).
See “Tires, Inspection
and Rotation”
in
the Index. Check the tires for
uneven wear or damage. If you see irregular or
premature wear, check the wheel alignment. Check
for damaged wheels also.
While the tires and wheels are removed for rotation,
perform
the
brake system inspection described
in
Section
C.
To Next Page
Loading...
