A
green arrow on the instrument panel
will
flash
in
the direction
of
the turn or
lane change.
To signal a lane change, just raise or
lower the lever
until
the green arrow starts
to flash. Hold
it
there
until
you complete
your lane change. The lever
will
return by
itself
when
you release
it.
As
you signal a turn or a lane change,
if
the
arrows don’t flash but just stay on, a
signal bulb may be burned out and other
drivers
won’t
see your turn signal.
If a bulb is burned out, replace
it
to
help
avoid an accident. If the green arrows
don’t go on at all when you signal a turn,
check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for
burned-out bulbs.
Operation
of
Lights
Although your vehicle’s lighting system
(headlights, parking lights, fog lamps,
sidemarker lights and taillights) meets all
applicable federal lighting requirements,
certain states and provinces may apply
their own lighting regulations that may
require special attention before you
operate these lights.
For example, some jurisdictions may
require that you operate your fog lamps
only when your lower beam headlights
are also
on,
or that headlights be turned
on whenever you must use your
windshield wipers. In addition, most
jurisdictions prohibit driving solely
with
parking lights, especially
at
dawn or dusk.
It is recommended that you check with
your own state or provincial highway
authority for applicable lighting
regulations.
Turn the outside part
of
the lever to
control the lights. There are three
positions
for
the light switch.
OFF:
All
lights are off.
-300::
The parking lights, taillights,
license plate light and the instrument
panel lighting come on. The
headlights are
off.
/,
,\
:The headlights and all other
operating lights come on.
.
‘8’’-
Lights On Reminder
If you
turn
the ignition off, remove the
key, open the door and leave
the
lights
on,
a chime
will
remind you to
turn
off your
lights.
55
...
To Next Page
Loading...
